Build A Homemade Cell Phone Jammer

px-Battery-and-power-switch1

Have a look at it and maybe you will build your own too.

Editor’s note: Building these is illegal in some countries, so hack responsibly.

Technical Details

Many cell phones use GSM800 mobile standard to operate, thus my VCO (sweeping oscillator) is tuned to the 800MHz frequency range. It may be quite difficult to make this one to work properly without some skills and good testing tools, but in result you will have the efficient VCO.

I used clock oscillator for 45MHz as the noise generator for this jammer. It drives the local oscillator port which is located at the mixer. The signal is going out from the local oscillator and passes through the impedance matching network along its way. This helps equate the impedance of 45MHz clock oscillator with the impedance of the mixer’s port.

This port acts like RF input of the signal jammer. The RF output signal passes through the amplifier on the mini-circuit. The output power is increased by additional 15-16dbm in this way. Then the output signal goes to the RF output antenna. RF input has the antenna too.

Jammer Operating

Why I chose 45MHz clock oscillator? Because GSM800 band transmitted and received signals are always separated by the exact number of frequency and it is that 45MHz. Now picture this: cell phone user dial someone and signal goes off. RF input antenna catches it and jammer modifies this signal and lets it go. This signal have a frequency of cell phone’s received signal, so cell phone user would hear his or her own voice in a phone! :)

I should also mention that this particular cell phone jammer might be used to block the signal of the cell-based car tracking device which records your GPS data and sends it to some bad guys. And it probably can even jam some IED signals if they are controlled by cell phone GSM800 band.

But I hope that there be no situation in this life when that feature will be needed by me, or you, or anyone else.

Photos And Some Notes

Jammer-circuit

Used mixer was originally made for 600MHz but I modified it a little and it works perfectly for 800MHz.

Jammer-circuit-top

The amplifier makes fantastic thing with output power. Despite it draws additional power supply, it is worth it.

600px-case-and-connectors

Jammer case was made from old aluminium box and UHF connectors I took from my old Motorola phone.

Mini-circuit-and-connectors

Those connectors must be soldered to the mini-circuit to work properly.

Battery-and-power-switch

To supply this little signal jammer the nine volts battery with voltage regulator is enough. I have separated it from other electronic components with foam plastic.

Cell-phone-jammer-ready

Don’t forget to make a power switch for your new creation. Oh, and attach antennas to the UHF connectors.

Cell-phone-jammer-prepared

So it is ready! Use it wisely ;)

Jammer Scheme

Cell-phone-jammer-scheme

 

[via wired]

Stay tuned at Techfat and follow us on Twitter and Google+ or join our Facebook Fanpage to keep yourself updated on all the latest News!

Comments